Networking Devices-Routers
RoutersRouters Are networking devices used to extend or segment networks by forwarding packets from one logical network to another. Routers are most often used in large internetworks that use the TCP/IP protocol suite and for connecting TCP/IP hosts and local area networks (LANs) to the Internet using dedicated leased lines.
.jpg)
Routers work at the network layer (layer 3) of the Open Systems Interconnection (OSI) reference model for networking to move packets between networks using their logical addresses (which, in the case of TCP/IP, are the IP addresses of destination hosts on the network). Because routers operate at a higher OSI level than bridges do, they have better packet-routing and filtering capabilities and greater processing power, which results in routers costing more than bridges.
cisco router
Routing tables
Routers contain internal tables of information called routing tables that keep track of all known network addresses and possible paths throughout the internetwork, along with cost of reaching each network. Routers route packets based on the available paths and their costs, thus taking advantage of redundant paths that can exist in a mesh topology network.
Because routers use destination network addresses of packets, they work only if the configured network protocol is a routable protocol such as TCP/IP or IPX/SPX. This is different from bridges, which are protocol independent. The routing tables are the heart of a router; without them, there's no way for the router to know where to send the packets it receives.
Unlike bridges and switches, routers cannot compile routing tables from the information in the data packets they process. This is because the routing table contains more detailed information than is found in a data packet, and also because the router needs the information in the table to process the first packets it receives after being activated. A router can't forward a packet to all possible destinations in the way that a bridge can.
Static routers: These must have their routing tables configured manually with all network addresses and paths in the internetwork.
Dynamic routers: These automatically create their routing tables by listening to network traffic.
Routing tables are the means by which a router selects the fastest or nearest path to the next "hop" on the way to a data packet's final destination. This process is done through the use of routing metrics.
Routing metrics which are the means of determining how much distance or time a packet will require to reach the final destination. Routing metrics are provided in different forms.
hop is simply a router that the packet must travel through.
Ticks measure the time it takes to traverse a link. Each tick is 1/18 of a second. When the router selects a route based on tick and hop metrics, it chooses the one with the lowest number of ticks first.
You can use routers, to segment a large network, and to connect local area segments to a single network backbone that uses a different physical layer and data link layer standard. They can also be used to connect LAN's to a WAN's.
Brouters
Brouters are a combination of router and bridge. This is a special type of equipment used for networks that can be either bridged or routed, based on the protocols being forwarded. Brouters are complex, fairly expensive pieces of equipment and as such are rarely used.
brouter
A Brouter transmits two types of traffic at the exact same time: bridged traffic and routed traffic. For bridged traffic, the Brouter handles the traffic the same way a bridge or switch would, forwarding data based on the physical address of the packet. This makes the bridged traffic fairly fast, but slower than if it were sent directly through a bridge because the Brouter has to determine whether the data packet should be bridged or routed.
